Kitec pipe replacement begins with a thorough inspection of accessible lines in walls, ceilings, and crawl spaces. The plumber identifies all affected sections, shuts off the main water supply, and removes the polybutylene tubing and brass fittings. New PEX or copper lines are run using the same pathways where possible, with connections made at existing fixtures and the main. In Utah County homes the work often includes rerouting around tight joist bays common in Lehi construction from the late 1990s.
Materials chosen are typically cross-linked polyethylene tubing rated for 160 psi or type L copper, both compatible with local water chemistry. High municipal pressure common in the area and the scaling effect of hard water accelerate stress on original fittings, so the plumber installs a pressure reducing valve where one is absent or undersized. All new work meets current Utah plumbing code requirements for support spacing and expansion loops.
Homeowners are warned that partial repairs often leave hidden sections that fail later, especially after winter temperature swings cause ground movement around foundations in Eagle Mountain and American Fork. Full replacement is usually recommended once Kitec is confirmed. The plumber documents every run replaced and provides a diagram for future reference before restoring water service and checking for leaks at every joint.
Technician insight
In Lehi, the thing that catches most people out with Kitec Pipe Replacement is how quickly the combination of 80-plus psi municipal pressure and hard water scale destroys the original brass crimp rings in homes built between 1995 and 2005. Many owners only notice the problem after a fitting lets go behind a wall during a cold snap when the ground shifts slightly.
Kitec Pipe Replacement Services We Offer
✓Kitec Pipe Inspection
Local plumber performs a full visual and pressure test of all visible Kitec lines to locate leaks and weak fittings before any replacement begins.
✓Full Kitec System Replacement
Complete removal of Kitec tubing throughout the home with new PEX or copper lines installed to current code standards.
✓Partial Kitec Removal
Targeted replacement of failed sections in kitchens or bathrooms while leaving sound runs in place when full replacement is not yet required.
✓Pressure Reducing Valve Installation
Addition or replacement of a pressure reducing valve to protect new piping from the high municipal supply pressure found across Utah County.
✓Kitec to PEX Conversion
Direct swap of Kitec lines for PEX tubing with new crimp or expansion fittings suited to hard water conditions in Lehi and Draper.
How it works
- 1
Initial Assessment
The referred plumber inspects all accessible Kitec lines and measures static pressure at multiple fixtures.
- 2
Scope And Material Planning
Homeowner reviews the extent of replacement needed and selects PEX or copper based on access and budget.
- 3
Line Removal And Installation
Old tubing is extracted and new lines are run, supported, and connected with code-compliant fittings.
- 4
Pressure Regulation And Testing
A pressure reducing valve is set if needed and the entire system is pressure tested before walls are closed.
Pricing
Pricing depends on the job and is discussed with the plumber after you call.